In this post, I’m going to discuss a mic that I’ve owned for a number of years: the Sennheiser e609 (also referred to as the “e609S” or “e609 Silver”). Like its sibling and confusingly-similar named Sennheiser e906, this dynamic mic is designed for use primarily as a guitar amp mic, but you could just as easily use it on a snare drum or rack tom of a drum kit. It employs a side-address design (similar to many large-diaphragm condensers) that makes it ideal for hanging it by the mic cable from the top of an amp, with the capsule pointing straight at the speaker. Some people will try this same trick with other dynamic mics (e.g. the Shure SM57), but that generally doesn’t work as well, because the source is off-axis with relation to the capsule. So if you like doing that sort of thing for miking an amp, the e609 may be just the thing for you. Even if you’re not hanging it by its cable and are putting it on a mic stand, it’s side-address design keeps the mic cable and connector pointing up or down instead of out, allowing the mic to sit closer to the amp and more out of the way than an SM57 or other similar mic. (more…)

For a number of years, my live sound system was limited to only two monitor mixes shared between 4 stage monitor speakers. So for a typical 4-piece rock band, the drummer & bass player might share a mix, and then the guitar player and singer would share a mix. Each band member had their own monitor speaker, but they did NOT have their own monitor mix. There were two reasons for this. First, my old analog mixer only had two pre-fader aux/monitor sends. Second, the power amp that I used for my monitors was a standard stereo/2-channel amp. However, when my analog mixer bit the dust, I purchased a new Behringer X-Air XR18. The XR18 has 6 Aux Buses, each of which can be assigned as a pre-fader monitor send. This opened up some new possibilities for me: if only I had a 4-channel power amp, I could run 4 separate, independent monitor mixes–one for each speaker. Enter the Behringer iNuke NU4-6000, a 4-channel amp that seemed to be tailor-made for my intended purpose. (more…)